LAN9514/en: различия между версиями

Новая страница: «3) Linux, apparently, is not able to do suspend of a device therefore if so to drive the driver with the activated GPIOs in suspend, it will constantly Wake up an…»
(Новая страница: «LAN9514»)
 
(Новая страница: «3) Linux, apparently, is not able to do suspend of a device therefore if so to drive the driver with the activated GPIOs in suspend, it will constantly Wake up an…»)
 
(не показаны 2 промежуточные версии этого же участника)
Строка 4: Строка 4:
[http://www.smsc.com/Technologies/PHYBoost/LAN951x LAN9514]
[http://www.smsc.com/Technologies/PHYBoost/LAN951x LAN9514]


== Управление питанием ==
== Power management ==
1) Можно отключить питание (?) ethernet-чипа через [[Питание USB-портов|hubpower]]
1) You can disable the Ethernet chip via [[Питание USB-портов/en|hubpower]]




2) Драйвер можно отправить в suspend2, при этом потребление падает:
2) The driver can be sent to suspend2, while the consumption drops:
<pre>
<pre>
echo "0" > "/sys/bus/usb/devices/$port/power/autosuspend"
echo "0" > "/sys/bus/usb/devices/$port/power/autosuspend"
Строка 14: Строка 14:
</pre>
</pre>


3) Линукс, судя по всему, не умеет делать suspend части девайса, поэтому если так загнать драйвер с активированными GPIO в suspend, то он будет постоянно просыпаться и засыпать обратно.
3) Linux, apparently, is not able to do suspend of a device therefore if so to drive the driver with the activated GPIOs in suspend, it will constantly Wake up and fall asleep back.
Потребление при этом кажется растёт не сильно:
Consumption does not seem to be growing much:
<pre>
<pre>
up + high 22.2
up + high 22.2
12 063

правки