Wiren Board 4:Первое включение/en: различия между версиями
(Новая страница: «== Before you start ==») |
(Новая страница: «500px|thumb|right|Wiren Board 4 #Check the microSD card. #:The memory card with the software image is supplied in the kit and is usually al…») |
||
Строка 5: | Строка 5: | ||
[[File:Firsttime.jpg|500px|thumb|right|Wiren Board 4]] | [[File:Firsttime.jpg|500px|thumb|right|Wiren Board 4]] | ||
# | #Check the microSD card. | ||
#: | #:The memory card with the software image is supplied in the kit and is usually already inserted ( into the top connector contacts inward upwards). If you don't have a microSD card, follow the [[Создание microSD-карты с образом#Запись готового образа на карточку |instructions]]. | ||
#Установите microSIM ''( | #Установите microSIM ''(optional)''. | ||
#:microSIM-карта | #:microSIM-карта is inserted into the lower connector with the contacts facing downwards at a cut-off angle. | ||
# | #Connect external antennas. | ||
#: | #:Screw the GSM and 433MHz antennas (optional) to the SMA connectors. | ||
# | #Turn off the button on the front panel. | ||
# | #Connect the power supply. | ||
#: | |||
#:Plug the power supply into the connector. If you are using a DIN rail or other power supply without a connector, simply clamp the wires into the Vin and Gnd terminals. It is also possible to power Passive Power over Ethernet. | |||
Версия 14:37, 7 июня 2019
Before you start
- Check the microSD card.
- The memory card with the software image is supplied in the kit and is usually already inserted ( into the top connector contacts inward upwards). If you don't have a microSD card, follow the instructions.
- Установите microSIM (optional).
- microSIM-карта is inserted into the lower connector with the contacts facing downwards at a cut-off angle.
- Connect external antennas.
- Screw the GSM and 433MHz antennas (optional) to the SMA connectors.
- Turn off the button on the front panel.
- Connect the power supply.
- Plug the power supply into the connector. If you are using a DIN rail or other power supply without a connector, simply clamp the wires into the Vin and Gnd terminals. It is also possible to power Passive Power over Ethernet.
Первое включение
- Первое включение устройства может занять длительное время (5-6 минут). Устройство загрузится (индикатор на лицевой панели из красного станет зелёным), создаст секретные ключи для SSH и проинициализирует серийный номер устройства, и перезагрузится ещё раз. Когда индикатор во второй раз станет зелёным, можно начать работу с устройством.
- Чтобы зайти в веб-интерфейс, надо узнать IP-адрес контроллера. Как это сделать, смотрите в статье Как узнать IP-адрес контроллера.
- Для настройки контроллера может понадобиться получить доступ к его консоли. Сделать это можно либо через сеть по SSH, либо подключившись напрямую через отладочный порт Debug UART.
Обновление ПО
Рекомендуем выполнить обновление ПО. См. [1]